| Software Specifications |
RG-S5350-E Series |
| Ethernet switching |
Jumbo frame (maximum length: 9,216 bytes) |
| 802.3az EEE |
| IEEE 802.1Q (4K VLANs) |
| Voice VLAN |
| Super-VLAN and private VLAN |
| MAC address-based VLAN, interface-based VLAN, protocol-based VLAN, and IP subnet-based VLAN |
| GVRP |
| Basic QinQ Selective QinQ |
| STP, (IEEE 802.1.d), RSTP, (IEEE 802.1w), and MSTP (IEEE 802.1s) |
| ERPS (G.8032) |
| LLDP/LLDP-MED |
| IP service |
Static and dynamic ARP, ARP proxy, and ARP entry timeout |
| DHCP client, DHCP relay, and DHCP server |
| DHCP snooping |
| DNS |
| DNS client, DNS proxy, and DNSv6 client |
| DHCPv6 client, DHCPv6 relay, and DHCPv6 server |
| DHCPv6 snooping |
| Neighbor Discovery (ND) and ND snooping |
| IP routing |
Static routing |
| RIP and RIPng |
| OSPFv2 and OSPFv3 |
| IS-ISv4 and IS-ISv6 |
| BGP4 and BGP4+ |
| IPv4 and IPv6 VRF |
| IPv4 and IPv6 PBR |
| Multicast |
IGMP v1/v2/v3, and IGMP proxy |
| IGMP v1/v2 snooping |
| PIM-DM, PIM-SM, and PIM-SSM |
| PIM SMv6, and PIM-SSMv6 |
| MSDP |
| MLDv1/v2 and MLD proxy |
| MLD snooping v1/v2 |
| PIM-SMv6 and PIM-SSM v6 |
| Multicast source IP address check Multicast source port check |
| Multicast querier |
| ACL and QoS |
Standard IP ACLs Extended IP (hardware ACLs Extended MAC ACLs Time-based ACLs Expert-level ACLs ACL80 IPv6 ACLon IP addresses) |
| Extended IP ACLs (hardware ACLs based on IP addresses or TCP/UDP port numbers) |
| Extended MAC ACLs (hardware ACLs based on source MAC addresses, destination MAC addresses, and optional Ethernet type) |
| Expert-level ACLs (hardware ACLs based on flexible combinations of the VLAN ID, Ethernet type, MAC address, IP address, TCP/UDP port number, protocol type, and time range) |
| Time based ACLS, ACL 80, and IPv6 ACL |
| Global ACLs |
| ACL redirection |
| Traffic rate limiting on an interface |
| Congestion management: RR, SP, WRR, DRR, WFQ, SP+WRR, SP+DRR, and SP+WFQ |
| Congestion avoidance: tail drop |
| 802.1p/DSCP/ToS traffic classification Eight priority queues per interface |
| Security |
Multiple AAA modes |
| RADIUS and TACAS+ |
| RADIUS authentication and authorization |
| IEEE802.1X authentication, MAC address bypass (MAB) authentication, and interface-based and MAC address-based 802.1X authentication |
| Web authentication |
| HTTPS |
| SSHv1 and SSHv2 |
| Global IP-MAC binding |
| ICMPv6 |
| Port isolation and port security |
| IP source guard |
| SAVI |
| ARP spoofing prevention |
| CPP and NFPP |
| Portal authentication and Portal 2.0 authentication |
| ARP check DAI ARP packet rate limiting Gateway ARP spoofing prevention |
| Broadcast storm suppression |
| Hierarchical management of administrators and password protection |
| BPDU guard |
| Port protection |
| Reliability |
REUP |
| RLDP |
| RLDP, Layer 2 link connectivity detection, and unidirectional link detection |
| DLDP |
| IPv4 VRRP v2/v3 and IPv6 VRRP |
| BFD, NSR, VRRR, VRRP+ |
| Basic LACP |
| Link tracing, fault notification, and remote loopback based on 802.3ah (EFM) |
| Dual-Boot Redundancy |
| Fan speed adjustment Fan fault alarm |
| Device virtualization |
Virtual Switching Unit (VSU) |
| NMS and maintenance |
SPAN, RSPAN |
| sFlow |
| NTP and SNTP |
| FTP and TFTP |
| SNMP v1/v2c/v3 |
| RMON (1, 2, 3, 9) |
| NETCONF |
| CWMP (TR-069) |
| gRPC |
| CLI (Telnet/Console) |
| Web |
| Syslog/Debug |
| Various types of RMON groups, including event groups, alarm groups, history groups, and statistics groups, as well as private alarm extension groups |
| RMON used to implement Ethernet statistics, historical statistics, and alarm functions |
| OpenFlow Special 1.3 Flow table analysis defined by all protocols Transmission of specified packets to the controller Configuring the controller's IP address and port Notifying port status changes to the controller |
| RNS, configuration rollback, and 802.3ah |
| 1:1 mirroring N:1 mirroring 1:N mirroring Flow-based local and remote mirroring |
| PoE |
RG-S5350-12GT4XS-P-E, RG-S5350-E-24GT4XS-P-E, and RG-S5350-E-48GT4XS-P-E IEEE 802.3af and 802.3at Warm start Port priority Automatic and energy-saving power supply management modes Uninterrupted power supply in hot start mode Scheduled power-on or power-off of PoE ports based on the time policy |
